Worktop fabrication in Anerley

Yes. Anerley is on the patch, and the postcodes we work here are SE20. It is worked on our south east London run, along with the rest of Bromley. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. That is the last thing settled before dispatch. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. The other constraint is the hall: a piece has to come through the front door, round the newel at the foot of the stairs and through a doorway into the back kitchen, so we size the pieces to the tightest turn on that route before we nest anything, which sometimes means splitting a run that would otherwise have gone in whole. The bench proves it before the van moves. Carrying stone up a raised front entrance on a hill is a two-plus-two job, and we allow for it in the pricing rather than turning up short-handed.

Streets run steeply up from the station with parking bays on the slope, and many houses have a flight of steps up to a raised front door before you even get inside. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch.

Peninsulas frequently land on a lightweight partition or on units that were never fixed down, and stone needs proper support under it before it goes on. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. The drawing decides it, not the fitter. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.