Worktop templating in Arkley

Yes. Arkley is on the patch, and the postcodes we work here are EN5. It is worked on our north London run, along with the rest of Barnet. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Doorways are low and narrow, which is a genuine constraint on piece length before anything else is considered. One datum for the whole room, because a floor that falls end to end shows as a step between island and perimeter. No stone is ever cut from a plan. Unloading on a fast road with no pavement is a genuine safety issue here, so the van goes onto the drive or the job gets rescheduled.

Houses sit back from a fast, narrow country-edge road with no footway in places, so unloading has to happen on the driveway rather than the roadside. Drives are long and often gravelled, and some properties are gated. Sign-in at the gate, a permit on the dash and a named contact are usually wanted before anything comes off the van. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. The template records it along with everything else.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop installation and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. Join positions and vein direction are marked on the template drawing before it leaves site. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. That is why the visit takes two or three hours. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.