Worktop templating in Bakers Arms

Yes. Bakers Arms is on the patch, and the postcodes we work here are E10, E17. It is worked on our east London run, along with the rest of Waltham Forest. Loading exemptions on red routes are narrow, time-limited and heavily camera-enforced, so we plan around them rather than relying on them. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The structure below is commercial, so the floor is often timber over a shop ceiling and the load path under an island is worth thinking about. Runs commonly finish at a doorway, and the architrave and skirting stand proud of the plaster, so the end of the top is notched or stopped on the drawing. Two to three hours, once the units are in. Rented and converted flats here mean a lot of like-for-like replacements around existing sinks and hobs, so the old top gets measured before it comes out.

The junction is a major bus corridor with red route sections and loading bans, so drops happen on the side streets which are permit-controlled and busy. Above-shop flats have a shared side door, a steep straight stair and no lift, so anything over about 2.2m needs jointing. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. That is part of what the visit is for.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Join positions and vein direction are marked on the template drawing before it leaves site. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Units fixed, packed level and pushed as far back as the leaning wall allows, walls made good to final thickness with tiling left until after the worktop, and the sink, tap and hob on site so cut-outs are set from the real items. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.