Kitchen worktops in Barkingside

Yes. Mostly modest inter-war and post-war semis where the kitchen has been extended a couple of metres into the garden rather than fully knocked about, giving an L-shape with the sink moved to the new rear wall and a 3m run down the long side. Quite a lot of straight like-for-like swaps here where the units are sound and only the tops have gone. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap.

1930s semi, post-war semi, 1960s terrace and modern flat. The window sits in the middle of the run over the sink, and its board and cill set the limit on how tall an upstand can be. Post-war terraces are typically blockwork or early lightweight block with a hard render coat, and the kitchen has usually been reconfigured at least once, leaving patched areas of newer plaster next to original render that sit at different depths. The wall makes that decision, not the brochure.

Easy suburban access on the residential roads with driveways and dropped kerbs; harder on the High Street itself and the flats above the parade, where there is no parking and stairs to the first floor. Where the van stands level with the front of the house a piece gets handled twice instead of five times, and stone breaks on handling rather than on the road. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. Joint positions follow from that.

Worktop replacement, worktop installation and worktop splashbacks & upstands, in that order. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly. Plenty of replacement-only work here, so the critical measurement is the existing carcass depth, older units are often 570mm rather than 600mm and the overhang has to be set accordingly.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. The units stay, the surface changes. Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Access for the whole slot, or a different day. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.