Worktop design and quotation in Bellingham

Yes. Bellingham is on the patch, and the postcodes we work here are SE6. It is worked on our south east London run, along with the rest of Lewisham. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. It sits in the fitting line as time on site rather than as anything to do with the stone. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Many have been extended at the rear since being sold, so the kitchen is half original and half newer with a floor junction between the two. The fixed lines do not shrink with the room, so on a small kitchen they are a larger share of the total than the stone. That is what the itemised lines are for. The larder recess and the original back-door position dictate the layout, and the sink almost always stays under the window.

Wide estate roads with verges, on-plot parking at many houses and easy turning; rear access is by long shared garden paths rather than side passages. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. You see that figure before we template, not after.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Nothing payable until we template. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Material is the slab only, and it says so.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The returns into a breast recess are the tightest scribes in the room, and they are eased in rather than forced. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send the run lengths plus a photo of every corner of the kitchen so we can spot boxed ducts, and tell us whether the sink is staying in the same position. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Written to be read by whoever is paying.