Kitchen worktops in Caledonian Road

Yes. A long spine of above-shop flats with side streets of Victorian terraces and big estates behind, so kitchens are small, fixed and quite often internal with no window at all. The newer canal-side flats are the exception, with open-plan runs of about 3m and a short island. Loading exemptions on red routes are narrow, time-limited and heavily camera-enforced, so we plan around them rather than relying on them. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. The waste run is planned, not improvised.

Victorian terrace, large post-war estate, canal-side new build and above-shop flat. The structure below is commercial, so the floor is often timber over a shop ceiling and the load path under an island is worth thinking about. Post-war terraces have small, roughly square kitchens with a back door and a window in the middle of the run, so runs are short and joins are rare, but there are usually two corners and a window cill to work around in a couple of metres. What is under the old top is the real question.

The road itself is narrow with bus lanes and peak-hour loading bans, and the estates behind have gated courtyards. Above-shop access is a single street door and a steep straight stair with no landing at the top to turn on. Sign-in at the gate, a permit on the dash and a named contact are usually wanted before anything comes off the van. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Worktop replacement, worktop fabrication and worktop installation, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. Internal kitchens with no window make dust control and extraction difficult, so cut off site wherever possible and bring the pieces in finished.

On a heavily veined stone the island and the run behind it are nested off the same area of slab so the movement relates across the room. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.