Worktop design and quotation in Camberwell

Yes. Camberwell is on the patch, and the postcodes we work here are SE5. It is worked on our south east London run, along with the rest of Southwark. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. It sits in the fitting line as time on site rather than as anything to do with the stone. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The back addition is a narrow two-storey outrigger with a single external wall, and the kitchen galley runs the length of it. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length, anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. That is what the itemised lines are for. Side-return extensions here often have bifolds set into a steel that has deflected slightly, so check the level along the whole rear run before templating.

Conservation-area streets with railed front gardens and steps up to the door, plus permit parking and a busy one-way system around the green - most slabs go in through the front hall past a stair newel. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. We price the carry from what you tell us about the route, so photographs of the approach are worth more to us than a floor plan. It appears as its own line rather than buried in a rate.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Itemised, so it can be compared honestly. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. This is the item most often left out of a cheaper quote, and it comes back as a variation once the templater has been. Better on the quote than in a variation. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Written to be read by whoever is paying.