Splashbacks and upstands in Ealing Common

Yes. Ealing Common is on the patch, and the postcodes we work here are W5. It is worked on our west London run, along with the rest of Ealing. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These houses usually sit in their own grounds with a long approach, so the carry from van to door is longer than anything inside the building. Long runs mean more than one piece, and the joint belongs in a corner or on a hob centre line rather than mid-run. The wall makes that decision, not the brochure. Those front steps mean every piece gets lifted over three or four risers, which is worth two extra hands rather than trying it with one.

Streets around the common are residents-only permit bays. Villas have deep front paths and a flight of steps up to a raised ground floor, and driveways are rare. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Sockets final before template. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. An upstand rides what a panel exposes. The range and extractor must be sited and the window cill finished before the template, as both fix the vertical limits of the splashback. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after.