Worktop design and quotation in Hayes End

Yes. Hayes End is on the patch, and the postcodes we work here are UB4. It is worked on our west London run, along with the rest of Hillingdon. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The classic arrangement is the original back room with a later extension bolted onto it, so the kitchen is two ages of building in one room. These are typically two runs and a return, often into a rear extension, and the return piece is the awkward one, short, wide and rarely nesting well against the long pieces on the slab, so slab yield rather than total area is what pushes the material line up. You see it before you commit to anything. The side extensions widen the room enough for an island, but the existing ceiling joists were never sized for a downdraught extractor run so check before you commit to a hob cut-out.

The Uxbridge Road is the bottleneck, but the side roads have wide drives and verges and a van can sit outside the property all day without trouble. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. It appears as its own line rather than buried in a rate.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Material is the slab only, and it says so.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Nothing payable until template.