Worktop installation in Hornsey

Yes. Hornsey is on the patch, and the postcodes we work here are N8. It is worked on our north London run, along with the rest of Haringey. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Lease conditions and the other flats in the building decide when noisy work can happen, so the fitting day has a start and a finish that are not ours to set. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. That is the shape of the day. Conversion kitchens here often sit on a solid ground-floor slab that has been overlaid twice - measure finished floor level at both ends of the run, not just at the sink.

The High Street is a constant bus corridor with red-route style restrictions at peak, so timing matters. New blocks need a booked service lift and dust sheets over the lobby finishes; the older conversions have a shared street door and a stair used by three flats. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. We walk the route with a tape and protect it end to end before the first piece is lifted. It gets checked before the first piece is lifted.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. The fitting day is scheduled to suit that rather than to suit the diary. The prep list is not optional. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. One visit, with the sink and hob seated and sealed before we leave. Sealed before we leave.

On a heavily veined stone the island and the run behind it are nested off the same area of slab so the movement relates across the room. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. Floors and units are protected before anything comes through the door, communal or otherwise. Access for the whole slot, or a different day.