Worktop replacement in Maida Hill

Yes. Maida Hill is on the patch, and the postcodes we work here are W9. It is worked on our central London run, along with the rest of Westminster. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The rear extension is frequently original rather than added, which means it is solidly built and just as far out of square as the rest of the house. What the old top has been hiding is usually a floor that settled towards the back and units that were never fixed back to the wall. Sound carcasses are the one condition. Social and rental stock here gets old base units that are already water-damaged at the sink - allow for replacing the sink base carcass rather than dropping stone onto swollen chipboard.

Estate blocks with fob entry, deck access and a single lift that is frequently in use by residents, plus restricted bays and enforcement on the estate roads. The Westway runs overhead nearby, so some approaches are one-way loops that add ten minutes. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. It sets what the day actually looks like.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop splashbacks & upstands. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. The units stay, the surface changes. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. Found at template, not on fit day. Have a plumber booked to disconnect the sink, tap and waste first thing and reconnect after we have gone, and clear the hallway and stairs completely so we can carry slabs through the house. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Sound carcasses are the condition.