Worktop replacement in Oakwood

Yes. Oakwood is on the patch, and the postcodes we work here are N14. It is worked on our north London run, along with the rest of Enfield. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Houses of this period came with generous garages and utility rooms, so a second short run of stone is often part of the same job. The kitchen is normally the original back room with a later side-return or rear extension bolted on, and that helps us: most pieces can go down the side alley and in through the back door in one length, so we can avoid joins that a front-door route would force. What is under the old top is the real question. Where the extension has a large rooflight, the island reads far brighter than a showroom does - check the sample on site before settling a dark colour.

Good - most houses have a driveway and the roads are wide, but the extensions themselves are often already built with the doors on, so the slab route is through the house rather than in from the garden. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. It sets what the day actually looks like.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. Height change is checked before we cut. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a run finishes into a reveal, the depth of that reveal is taken at worktop height and nowhere else. We would rather find it at template than on the morning, which is why the templater looks behind the units. It is the usual surprise, and it is a known one. Unlock the side gate and clear the alley of bins, bikes and pots, and arrange a plumber for the sink and an electrician if the hob is hard-wired. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed.