Worktop fabrication in Palmers Green

Yes. Palmers Green is on the patch, and the postcodes we work here are N13. It is worked on our north London run, along with the rest of Enfield. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A bay-fronted terrace has a long hall running past the stairs to the kitchen, so the hall turn caps the piece length before the run length does. The other constraint is the hall: a piece has to come through the front door, round the newel at the foot of the stairs and through a doorway into the back kitchen, so we size the pieces to the tightest turn on that route before we nest anything, which sometimes means splitting a run that would otherwise have gone in whole. The bench proves it before the van moves. Islands here are frequently over 3m and need two men either side plus a joint or a slab upgrade - check the ceiling height for the bifold head before you plan the lift-in route.

Green Lanes has controlled parking, a bus lane and loading restrictions outside the shops, and the side streets are permit-only in the day. Houses generally have a side gate wide enough for a slab if the front hall is too tight. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where an annexe has been built or converted, its floor and its walls are newer than the main house and behave differently under the same run. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. Households sharing a house tend to want two prep areas rather than one, which usually means an island as well as a perimeter run. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.