Kitchen worktops in Putney Heath

Yes. Postwar blocks around the heath have separate kitchens of a fixed size with a sink under the window and a hatch to the dining area, and the usual work is a like-for-like top with matching upstands. The detached houses backing onto the heath take larger open-plan schemes with an island. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. The waste run is planned, not improvised.

Interwar detached, 1950s and 60s purpose-built block and Postwar estate housing. Base units from the seventies and eighties are often only 500mm deep, so a 600mm stone top overhangs at the front and the doors want checking against it. That step is exactly what an upstand covers and what a full-height panel exposes, so unless the wall is skimmed level end to end, a 100mm band is the reliable choice. The wall makes that decision, not the brochure.

The blocks are set in landscaped grounds with parking courts some distance from the entrances, so there is a long paved carry before you reach any lift or stair. Lifts in these blocks are small passenger cars that will not take a full slab upright. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. It decides panel size before anything is cut.

Worktop replacement, worktop splashbacks & upstands and worktop installation, in that order. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The fitting day is scheduled to suit that rather than to suit the diary. The prep list is not optional. Hatch openings between kitchen and dining room mean the worktop often has to be finished on two faces and polished on the exposed edge inside the opening.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Corners get their own pieces. A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. The fitting day is arranged with whoever can actually give us access for the whole slot. Protection goes down first. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.