Kitchen worktops in Riddlesdown

Yes. Inter-war stock strung along the ridge, mostly semis with a rear kitchen extended by 2-3m to make a kitchen-diner with a peninsula and garden doors. Wall runs of about 3.6m are typical and full islands are rare because the rooms are long rather than wide. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is.

1930s semi, 1930s detached, post-war infill and chalet bungalow. A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. Access is usually the easy part here, as most of these have a side gate and a back door straight into the kitchen, so we carry down the side alley rather than through the house and keep the mess outside. That is the shape of the day.

Narrow hillside roads with parking on both sides and short steep drives, plus the railway cutting means several streets are dead ends with no turning space for a long van. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Worktop installation, worktop replacement and worktop templating, in that order. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. Dead-end hillside roads mean reversing a loaded van out, so we take the smaller vehicle here and make two trips rather than one.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. The units stay, the surface changes. The returns into a breast recess are the tightest scribes in the room, and they are eased in rather than forced. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.