Splashbacks and upstands in Sanderstead

Yes. Sanderstead is on the patch, and the postcodes we work here are CR2. It is worked on our south London run, along with the rest of Croydon. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Upstands travel in a crate and can wait on the van, which gives some flexibility a full-height panel does not. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Solid brick with a render coat is firm to work against and out of plumb, so the scribe at worktop height is different from the one at plinth level. These kitchens are nearly always retiled at least twice, and stripping the old tiles takes the bottom course of plaster with it because the original laminate top ran underneath the tiles rather than up to them. The wall makes that decision, not the brochure. Split-level rear extensions mean two worktop heights in one room, and clients often want a continuous stone look across the step, which has to be resolved as two separate runs with a deliberate break.

Hilly roads with steep, often curved driveways and split-level frontages, so getting close to the door is fine but the last few metres involve a slope or a set of steps. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Siliconed to the worktop, never grouted. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Same batch, same run, same day.

On a heavily veined stone the island and the run behind it are nested off the same area of slab so the movement relates across the room. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. Make the wall good first, or accept the detail. The old tiling must be off and the wall made good and dry before templating, not on fitting day. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Full-height panels need the wall made good first, which is another trade and another timescale. Same slab run as the tops.