Kitchen worktops in South Ealing

Yes. Edwardian terraces with the standard side-return infill, producing a 5m single-wall galley plus a slim island, rooflights overhead and the run terminating at a set of bifolds. Loading exemptions on red routes are narrow, time-limited and heavily camera-enforced, so we plan around them rather than relying on them. It sits in the fitting line as time on site rather than as anything to do with the stone. It is one line among the others, and it is honest.

Edwardian terrace, Victorian terrace, 1930s semi and small modern block. The addition wall is half a brick thick in places and has usually had a damp course injected and been re-plastered, which leaves it neither flat nor consistent. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. Walked, measured, protected, then lifted.

South Ealing Road is a busy bus corridor with permit parking either side, and once the side return is built out the terraces have no side access left at all. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Worktop installation, worktop templating and worktop design & quotation, in that order. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. With the return infilled there is no route to the garden, so the slab either goes in before the bifold doors are hung or it does not go in.

The step or level change between the original room and the return is real, and the units need packing before stone goes across it. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Sill height gets settled with the template on site, because it is one of the few dimensions nobody has measured before we arrive. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.