Worktop fabrication in Southborough

Yes. Southborough is on the patch, and the postcodes we work here are KT6. It is worked on our south west London run, along with the rest of Kingston upon Thames. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Handmade brick and lime plaster move visibly along a run, and a straight-cut back edge shows it immediately. The joins here are chosen rather than forced, so they go where the veining and the gables want them. Every join over a gable, clear of every cut-out. Raised ground floors mean four or five front steps on most jobs, so the lift plan and step protection matter more than the drive length.

Wide roads with in-and-out driveways and space to park the van clear of the highway, though several houses sit behind a long gravel approach and steps up to a raised ground floor. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch.

On a heavily veined stone the island and the run behind it are nested off the same area of slab so the movement relates across the room. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The range or Aga, the sink and the tap all need to be confirmed by model before nesting, because their clearances and hole positions set where the island can be cut. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.