Worktop fabrication in Stockwell

Yes. Stockwell is on the patch, and the postcodes we work here are SW9, SW8. It is worked on our south London run, along with the rest of Lambeth. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Georgian houses put the kitchen in a basement or a rear closet wing, and the stairs down to it are the tightest part of the whole route. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. The bench proves it before the van moves. Subdivided villas have kitchens fitted into rooms with original cornice and skirting, so the back edge has to be scribed around a skirting that is often 20mm proud at the bottom.

Estate blocks have secure entry, narrow lifts and shared stairs, and the parking courts sit away from the entrances. Villa properties have railed front steps and a lower-ground area entrance that is the only realistic way in for stone. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.