Worktop fabrication in Stonecot Hill

Yes. Stonecot Hill is on the patch, and the postcodes we work here are SM3. It is worked on our south London run, along with the rest of Sutton. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. That is the last thing settled before dispatch. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original quarry-tiled floors sit lower than a later screed, so a run crossing that junction needs the units packed to one level. What does drive the bench work is the knocked-through kitchen-diner: the return worktop and any peninsula are seen end-on from the dining side, so we nest the pieces so the veining carries across the internal corner in the same direction rather than turning through ninety degrees. The bench proves it before the van moves. Working off a forecourt on the arterial road means cones and a spotter, and we bring the pieces straight in rather than staging them on the drive.

The houses front a dual carriageway with a service road or a wide forecourt drive, which is fine for parking but means unloading with fast traffic passing a few metres away. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. The approved drawing is the instruction.