Kitchen worktops in Turnpike Lane

Yes. Terraced houses split into flats plus a lot of accommodation above the shops on the High Road, so kitchens are small, awkwardly shaped, and often lit only by a rooflight or a light well. A 2.2m run with a slimline dishwasher is a common brief. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap.

Victorian terrace, flat above shop and 1930s purpose-built flat. Lease conditions and the other flats in the building decide when noisy work can happen, so the fitting day has a start and a finish that are not ours to set. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. Walked, measured, protected, then lifted.

The High Road has bus lanes, a station entrance and permanent loading pressure - realistically you are working before 9am or unloading in a side street. Flats over shops mean a street door between two shopfronts and a steep straight stair with no half-landing. Weight tells on a staircase more than anywhere else, because there is nowhere to set a piece down mid-flight and no way to change your grip once it is moving. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Worktop replacement, worktop installation and worktop templating, in that order. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order. Straight steep stairs with no landing are the constraint - a 3m slab cannot be tilted on the way up, so plan for two shorter pieces jointed in the kitchen.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. The laminate has been covering it up. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Protection goes down first. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.