Splashbacks and upstands in Wallend

Yes. Wallend is on the patch, and the postcodes we work here are E6. It is worked on our east London run, along with the rest of Newham. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The chimney breast in the corner has usually been left in place, so the run gains a return and two scribed ends. These kitchens are nearly always retiled at least twice, and stripping the old tiles takes the bottom course of plaster with it because the original laminate top ran underneath the tiles rather than up to them. The wall makes that decision, not the brochure. Side access and a straight rear run mean single-piece tops are usually achievable here, so the design conversation is about overhangs, not joints.

Most houses have a driveway or a crossover and a side gate wide enough for a slab on edge, which makes this some of the simplest access in the borough. Roads are quiet and unrestricted in parts, so a full-size van can sit outside without a permit dispensation. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop replacement and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Same batch, same run, same day. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Siliconed to the worktop, never grouted.

The return piece is the awkward one on a slab: short, full depth, and rarely nesting neatly against the long lengths, so yield rather than area is what moves the material figure. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. The old tiling must be off and the wall made good and dry before templating, not on fitting day. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after.