Kitchen worktops in West Ealing

Yes. Heavy on two-flat conversions: the ground floor gets the rear-return kitchen, the upper flat gets a galley in what was a bedroom. Runs of 2.2m to 3m with the sink under an existing window. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause.

Victorian terrace, Edwardian terrace, two-flat conversion and Elizabeth line new-build. Lease conditions and the other flats in the building decide when noisy work can happen, so the fitting day has a start and a finish that are not ours to set. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the template picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Recorded as it is, not as it was drawn.

The Broadway and Uxbridge Road are red route with bus lanes, the side streets are permit-controlled, and the new blocks near the station have loading bays that must be booked in advance. Weight tells on a staircase more than anywhere else, because there is nowhere to set a piece down mid-flight and no way to change your grip once it is moving. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. The template records it along with everything else.

Worktop replacement, worktop installation and worktop templating, in that order. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Upper-flat kitchens sit on timber joists in a former bedroom, so a stone island is usually off the table and the client needs telling early.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.