Kitchen worktops in West Heath

Yes. Interwar semis on the high ground above Abbey Wood with rear kitchens and separate dining rooms; most have been opened up or extended to the rear for a 3.4m run and a peninsula, and side garages are often converted to utility space. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause.

1930s semi, interwar detached and postwar infill. Original quarry-tiled floors sit lower than a later screed, so a run crossing that junction needs the units packed to one level. The fitting itself is slower than the carry: original plaster on the party wall and around the old chimney breast is rarely square to the run, so back scribes get cut on site, and where a return wraps into a breast recess we template that shoulder tight and ease it in. That is the shape of the day.

Quiet sloping residential roads with drives on most houses and good turning space; the descent toward Abbey Wood is steep but wide enough. Where the van stands level with the front of the house a piece gets handled twice instead of five times, and stone breaks on handling rather than on the road. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

Worktop installation, worktop replacement and worktop templating, in that order. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. Converted garages are a common second worktop run, different floor level and usually a damp-prone external wall to check first.

The free end is what needs deciding early: square edge, mitred apron down the end, or a full waterfall to the floor, and a waterfall is cut in sequence off the same part of the slab. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The fitting day is arranged with whoever can actually give us access for the whole slot. Protection goes down first. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.