Worktop templating in Whitton

Yes. Whitton is on the patch, and the postcodes we work here are TW2. It is worked on our west London run, along with the rest of Hounslow. The practical answer is to check the fixture list before the date is offered, because a template slot lost to a road closure cannot be recovered that week. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. Where the room has been knocked through to the dining room or opened into a later extension, the two floors rarely sit at the same level and the whole opening has to be shot across from one datum. Two to three hours, once the units are in. Check the fixture list before you book the fit, because you will not get a van anywhere near Whitton on a match day.

Driveways on most streets, but the High Street bays are metered and Twickenham stadium road closures shut the approach routes on match Saturdays. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. All base units in, including anything standing on the later extension slab, walls skimmed to final thickness, and the sink, tap and hob delivered so cut-outs and tap centres are set from the actual items. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.