Kitchen worktops in Albany Park

Yes. A single large interwar estate built alongside the station, so house types repeat almost exactly: rear kitchen around 2.4m by 2.7m with a side door, dining room in front, and a knock-through producing a 3.4m run and a breakfast bar. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. The day is built around that window.

1930s Albany Park estate semi, interwar terrace and postwar infill. Solid walls with no cavity have often been dry-lined internally at some point, and the lining thickness varies from wall to wall. The kitchen is normally the original back room with a later side-return or rear extension bolted on, and that helps us: most pieces can go down the side alley and in through the back door in one length, so we can avoid joins that a front-door route would force. What is under the old top is the real question.

A uniform grid of wide roads with drives and dropped kerbs on most houses; parking is easy except right around the station at commuter times. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Worktop replacement, worktop installation and worktop templating, in that order. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. Because the house types repeat, so do the surprises, the same buried chimney breast and the same sagging back wall in every one.

The free end is what needs deciding early: square edge, mitred apron down the end, or a full waterfall to the floor, and a waterfall is cut in sequence off the same part of the slab. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.