Kitchen worktops in Longlands

Yes. Semis and chalet bungalows on the slope down to the Cray valley. Bungalow kitchens are square with low ceilings and sills close to the worktop, while the semis follow the usual rear-kitchen-plus-dining-room plan. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap.

1930s semi, interwar chalet bungalow and postwar terrace. Bungalow kitchens are frequently extended into the rear or opened into the roof space, so the room is part original and part new build. What catches people out is the junction between the old floor and the extension floor, which is rarely at the same level, so a run carrying across it needs the units packed before stone goes on. What is under the old top is the real question.

Sloping residential roads with drives on most houses, though a few streets narrow sharply toward the railway with little turning space for a long van. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Worktop replacement, worktop installation and worktop templating, in that order. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. Low window sills in the bungalows kill a standard 100mm upstand, so measure sill height at template stage.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Where a run finishes into a reveal, the depth of that reveal is taken at worktop height and nowhere else. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Sound carcasses are the condition. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.