Worktop templating in Aldersbrook

Yes. Aldersbrook is on the patch, and the postcodes we work here are E12. It is worked on our east London run, along with the rest of Redbridge. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The rear wall is usually a single brick thick and has been rendered, patched and re-rendered, so it bows in and out along the length of the run. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. Recorded as it is, not as it was drawn. That hallway turn into the rear addition is the constraint on nearly every Aldersbrook house, and it decides where the joint goes before anything else does.

Straight terraced streets with permit parking and no driveways, and the side returns are enclosed once glazed, so slabs go in through the house, front door, hall, and a right turn at the back. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop replacement. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.