Worktop installation in Beddington

Yes. Beddington is on the patch, and the postcodes we work here are SM6, CR0. It is worked on our south London run, along with the rest of Sutton. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. We aim for the first slot of the day where parking is tight, because that is when the street is emptiest. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Houses of this period came with generous garages and utility rooms, so a second short run of stone is often part of the same job. The carry is the easy part; the plaster around the old breast and the packing over a moved floor are not. The slow parts are slow for a reason. The park-side houses tend to want honed or textured finishes rather than polished, and those show fingerprints and installation marks far more, so the pieces get handled with clean gloves from the van in.

Generally easy with driveways and wide roads, although the park-side properties have long front paths and gravel or block-paved drives that slope towards the road. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. The fitting day is planned backwards from that point, before anything comes off the van. It gets checked before the first piece is lifted.

It is one of the three we do most here, behind worktop design & quotation. Same template visit, same workshop, same installers either way. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. One visit, with the sink and hob seated and sealed before we leave. The prep list is not optional.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Unlock and clear the side gate and back door, and move bins, planters and washing lines out of the alley run. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Protection goes down first.