Worktop fabrication in Beddington

Yes. Beddington is on the patch, and the postcodes we work here are SM6, CR0. It is worked on our south London run, along with the rest of Sutton. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Houses of this period came with generous garages and utility rooms, so a second short run of stone is often part of the same job. Where a full length can come down the side and in at the back, the nest follows the slab instead of the building. The bench proves it before the van moves. The park-side houses tend to want honed or textured finishes rather than polished, and those show fingerprints and installation marks far more, so the pieces get handled with clean gloves from the van in.

Generally easy with driveways and wide roads, although the park-side properties have long front paths and gravel or block-paved drives that slope towards the road. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop installation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us.

The return piece is the awkward one on a slab: short, full depth, and rarely nesting neatly against the long lengths, so yield rather than area is what moves the material figure. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. The drawing decides it, not the fitter. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. The approved drawing is the instruction.