Worktop fabrication in Waddon

Yes. Waddon is on the patch, and the postcodes we work here are CR0. It is worked on our south London run, along with the rest of Croydon. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These kitchens have been retiled at least twice, and stripping the tiles takes the bottom band of plaster with them because the old laminate ran underneath rather than up to them. Most of these have a side passage and a back door, so a full-length piece can usually reach the kitchen without being cut down, and the piece sizing is driven by the slab rather than the route. Settled on the drawing, cut once. Knocking a semi's kitchen into the dining room leaves a downstand beam and a floor level change at the threshold, so the run has to be set out from the new opening and not the old wall.

Good vehicle access with driveways on most residential roads, though anything near Purley Way means retail traffic and awkward turns in and out. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop replacement and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. The approved drawing is the instruction.