Worktop fabrication in Beddington Corner

Yes. Beddington Corner is on the patch, and the postcodes we work here are CR4, SM6. It is worked on our south London run, along with the rest of Sutton. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. That is the last thing settled before dispatch. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A two-up two-down has a kitchen that was never designed to be one, so the run is short, the ceiling is low and every millimetre of depth gets argued over. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. Settled on the drawing, cut once. Exposed services above the run in the converted buildings mean the upstand height has to be checked against the lowest pipe, not assumed at a standard 100mm.

Industrial traffic on the approach roads, narrow terraced streets with no off-street parking, and low railway and river bridges that dictate the route in. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Sill height gets settled with the template on site, because it is one of the few dimensions nobody has measured before we arrive. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Machined to the real line. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction.