Worktop fabrication in South Beddington

Yes. South Beddington is on the patch, and the postcodes we work here are SM6. It is worked on our south London run, along with the rest of Sutton. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The back door frequently opens straight into the kitchen, which is the best carry route in the house and the one people forget to mention. Where a full length can come down the side and in at the back, the nest follows the slab instead of the building. The bench proves it before the van moves. Straight replacement work on 1930s units means the old tiled splashback usually comes off with the top, so an upstand is the practical answer rather than retiling the wall.

Straightforward suburban access with front drives, dropped kerbs and side gates, and quiet enough streets that a van can sit outside for a couple of hours without causing a problem. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.