Worktop design and quotation in South Beddington

Yes. South Beddington is on the patch, and the postcodes we work here are SM6. It is worked on our south London run, along with the rest of Sutton. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. It sits in the fitting line as time on site rather than as anything to do with the stone. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

There is usually a shared rear alley, and whether the gate onto it is unlocked decides whether long pieces come in from the back. Walls between the original room and the extension are frequently out of square, which affects the template but not the price; what does affect it is the appliance list, because a drop-in range, an undermount bowl and a half, a boiling tap and a separate drainer are four separately priced cut-outs. That is what the itemised lines are for. Straight replacement work on 1930s units means the old tiled splashback usually comes off with the top, so an upstand is the practical answer rather than retiling the wall.

Straightforward suburban access with front drives, dropped kerbs and side gates, and quiet enough streets that a van can sit outside for a couple of hours without causing a problem. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. It appears as its own line rather than buried in a rate.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Itemised, so it can be compared honestly. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Every line has a reason next to it.