Worktop fabrication in Little Woodcote

Yes. Little Woodcote is on the patch, and the postcodes we work here are SM5, CR8. It is worked on our south London run, along with the rest of Sutton. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A period cottage has low ceilings, thick rubble-filled walls and a floor that has never been level, and the worktop is the thing that has to look straight. The joins here are chosen rather than forced, so they go where the veining and the gables want them. Settled on the drawing, cut once. The tracks up here are rough enough that we transport on edge in a padded frame and check every piece on arrival before it goes anywhere near the house.

Unmade lanes and farm tracks with potholes and mud, gated entrances and long gravel drives, and no street lighting, so winter fits have to be finished well before dark. Where the parking court sits behind the block the carry crosses open ground and gets boarded, because loaded trolleys and block paving do not agree. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Radiused, polished, and clear of the joins. The range or Aga, the sink and the tap all need to be confirmed by model before nesting, because their clearances and hole positions set where the island can be cut. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Changes cost a piece, not a tweak.