Worktop fabrication in Belmont

Yes. Belmont is on the patch, and the postcodes we work here are HA3. It is worked on our north west London run, along with the rest of Harrow. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The chimney breast in the corner has usually been left in place, so the run gains a return and two scribed ends. What does drive the bench work is the knocked-through kitchen-diner: the return worktop and any peninsula are seen end-on from the dining side, so we nest the pieces so the veining carries across the internal corner in the same direction rather than turning through ninety degrees. Settled on the drawing, cut once. Knock-through kitchens leave a stub of the old dividing wall, and that stub is almost never plumb, so template it rather than assume a straight line to the return.

Quiet residential roads with drives and straightforward kerbside loading, plus maisonettes over the parade shops that need an external rear staircase and a careful turn at the top. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. So the nesting is worked to the measured route first and to the slab second. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match.

A peninsula is an island with one end tied to a run, which means the join between them has to be planned rather than allowed to happen. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Dry-assembled before it leaves.