Splashbacks and upstands in Bexleyheath

Yes. Bexleyheath is on the patch, and the postcodes we work here are DA6, DA7. It is worked on our south east London run, along with the rest of Bexley. A dedicated loading bay or service yard is the easiest arrangement in a managed building, provided the slot is booked and someone has the key to the shutter. Upstands travel in a crate and can wait on the van, which gives some flexibility a full-height panel does not. That is why they are crated the way they are. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A detached house of this age has a drive, a side path and a back door, so access is rarely the constraint and the design can follow the room. That leaves a ragged band right where the upstand has to sit, which is fine for a 100mm upstand that covers it, but a full-height splashback needs the wall made good first or it will rock on the high spots. The wall makes that decision, not the brochure. Easy access and big rooms mean full-length single pieces are usually deliverable, the check is whether the extension floor finished level with the original.

Nearly every house has a drive and a dropped kerb, roads are wide and there is real turning room; only the town centre around the Broadway has serious loading restrictions. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. Where the route is tight we break a long splashback at a natural vertical joint instead of forcing one panel through. That is agreed at template, not on fitting day.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop design & quotation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Same batch, same run, same day. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Sockets final before template.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Long runs almost never take a single panel, so the joint positions want agreeing before anything is templated. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. The old tiling must be off and the wall made good and dry before templating, not on fitting day. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. The wall has to be ready.