Worktop installation in Bexleyheath

Yes. Bexleyheath is on the patch, and the postcodes we work here are DA6, DA7. It is worked on our south east London run, along with the rest of Bexley. Underground loading has a height restriction, and a van with an A-frame on it is taller than the driver remembers. We aim for the first slot of the day where parking is tight, because that is when the street is emptiest. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Solid brick with a render coat is firm to work against and out of plumb, so the scribe at worktop height is different from the one at plinth level. The fitting itself is slower than the carry: original plaster on the party wall and around the old chimney breast is rarely square to the run, so back scribes get cut on site, and where a return wraps into a breast recess we template that shoulder tight and ease it in. The slow parts are slow for a reason. Easy access and big rooms mean full-length single pieces are usually deliverable, the check is whether the extension floor finished level with the original.

Nearly every house has a drive and a dropped kerb, roads are wide and there is real turning room; only the town centre around the Broadway has serious loading restrictions. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. The fitting day is planned backwards from that point, before anything comes off the van. It gets checked before the first piece is lifted.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop design & quotation and worktop templating. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. One visit, with the sink and hob seated and sealed before we leave. The prep list is not optional.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. The back edge is eased in progressively rather than offered up once and forced. Dry-lay, mark, cut, then bond. Unlock and clear the side gate and back door, and move bins, planters and washing lines out of the alley run. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The fitting day is arranged with whoever can actually give us access for the whole slot. One visit, our own installers.