Worktop design and quotation in Biggin Hill

Yes. Biggin Hill is on the patch, and the postcodes we work here are TN16. It is worked on our south east London run, along with the rest of Bromley. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Tell us at enquiry stage and it is priced properly, because a crew stood waiting is the most expensive thing on any job. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Wide doorways and level thresholds mean full-length pieces go in whole and the join count comes down to slab length alone. These are typically two runs and a return, often into a rear extension, and the return piece is the awkward one, short, wide and rarely nesting well against the long pieces on the slab, so slab yield rather than total area is what pushes the material line up. Priced from the building, not from a rate card. Long shallow runs across a patchwork of extension walls throw out the depth, so we template the front edge as a straight line and take the variation on the scribe at the back.

The whole area is on a steep hill, and driveways run sharply up or down off the road. Steep, sloping drives are the problem, because a loaded trolley will not hold on a gradient and slabs get carried by hand. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. That is why the fitting line on a quote reflects manpower and time rather than square metres. Nothing about it gets estimated after the fact.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Nothing payable until we template. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Photographs are worth more than a plan here. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Written to be read by whoever is paying.