Worktop installation in Biggin Hill

Yes. Biggin Hill is on the patch, and the postcodes we work here are TN16. It is worked on our south east London run, along with the rest of Bromley. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. We aim for the first slot of the day where parking is tight, because that is when the street is emptiest. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Bungalow kitchens are frequently extended into the rear or opened into the roof space, so the room is part original and part new build. The fitting itself is slower than the carry: original plaster on the party wall and around the old chimney breast is rarely square to the run, so back scribes get cut on site, and where a return wraps into a breast recess we template that shoulder tight and ease it in. The slow parts are slow for a reason. Long shallow runs across a patchwork of extension walls throw out the depth, so we template the front edge as a straight line and take the variation on the scribe at the back.

The whole area is on a steep hill, and driveways run sharply up or down off the road. Steep, sloping drives are the problem, because a loaded trolley will not hold on a gradient and slabs get carried by hand. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. One visit, with the sink and hob seated and sealed before we leave. The prep list is not optional. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Unlock and clear the side gate and back door, and move bins, planters and washing lines out of the alley run. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Protection goes down first.