Worktop fabrication in Blackfen

Yes. Blackfen is on the patch, and the postcodes we work here are DA15. It is worked on our south east London run, along with the rest of Bexley. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. Where a full length can come down the side and in at the back, the nest follows the slab instead of the building. The bench proves it before the van moves. The original larder recess is usually where the tall units end up, plan the return around it rather than losing 400mm of run.

Wide roads with verges, drives and dropped kerbs almost everywhere; the shopping parade is the only stretch with waiting restrictions. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop replacement and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. The drawing decides it, not the fitter. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. Dry-assembled before it leaves.