Kitchen worktops in Blackheath Standard

Yes. Two very different jobs sit side by side: modest Victorian terraces with back-addition galleys, and the Span-designed 1960s houses around Vanbrugh Park where kitchens are compact, planned to the millimetre and open to the living space through a serving gap. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause.

Victorian terrace, 1930s semi and 1960s Span estate at Vanbrugh Park. Base units from the seventies and eighties are often only 500mm deep, so a 600mm stone top overhangs at the front and the doors want checking against it. Post-war terraces have small, roughly square kitchens with a back door and a window in the middle of the run, so runs are short and joins are rare, but there are usually two corners and a window cill to work around in a couple of metres. Units kept, surface changed, one day.

The Span courtyards are car-free with communal parking set back from the houses, so it is a barrow or carry across paving; the Victorian streets have permit bays and nothing else. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. It sets what the day actually looks like.

Worktop replacement, worktop templating and worktop splashbacks & upstands, in that order. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. On the Span houses keep to slim profiles and modest overhangs, the original joinery and window lines are tight and a chunky mitred edge reads wrong immediately.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. Where a run finishes into a reveal, the depth of that reveal is taken at worktop height and nowhere else. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Decided before fabrication, not after. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.