Worktop installation in Blackheath Standard

Yes. Blackheath Standard is on the patch, and the postcodes we work here are SE3, SE7. It is worked on our south east London run, along with the rest of Greenwich. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. We aim for the first slot of the day where parking is tight, because that is when the street is emptiest. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The window sits in the middle of the run over the sink, and its board and cill set the limit on how tall an upstand can be. The fitting itself is about squaring up to walls that look modern and are not: block or breeze walls with a skim that has been patched over decades, so we still dry-lay and scribe rather than trust the template edge. The slow parts are slow for a reason. On the Span houses keep to slim profiles and modest overhangs, the original joinery and window lines are tight and a chunky mitred edge reads wrong immediately.

The Span courtyards are car-free with communal parking set back from the houses, so it is a barrow or carry across paving; the Victorian streets have permit bays and nothing else. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. The fitting day is planned backwards from that point, before anything comes off the van. It gets checked before the first piece is lifted.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. One visit, with the sink and hob seated and sealed before we leave. One visit, done properly. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Joins are pulled with suction clamps and finished flush, then colour-matched, which is the last thing done rather than the first. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a run finishes into a reveal, the depth of that reveal is taken at worktop height and nowhere else. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Unlock any rear or shared path gate and clear both the hall and the back approach so we can choose the better route on the day. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Protection goes down first.