Worktop fabrication in Botany Bay

Yes. Botany Bay is on the patch, and the postcodes we work here are EN2. It is worked on our north London run, along with the rest of Enfield. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A period cottage has low ceilings, thick rubble-filled walls and a floor that has never been level, and the worktop is the thing that has to look straight. Access is off a drive and through wide doors, so for once the piece size is not the constraint - the joins that go in are the ones we choose for layout and veining, not the ones the building forces. Every join over a gable, clear of every cut-out. Range cookers in these houses sit in a masonry recess that is never square - template the two flanking tops individually with a tolerance gap, do not assume a symmetrical opening.

Narrow lanes with no pavement, no lighting and passing places only, plus horses and farm traffic. A long-wheelbase van fits but reversing out is not an option, so turning space has to be confirmed first. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The range or Aga, the sink and the tap all need to be confirmed by model before nesting, because their clearances and hole positions set where the island can be cut. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction.