Splashbacks and upstands in Brimsdown

Yes. Brimsdown is on the patch, and the postcodes we work here are EN3. It is worked on our north London run, along with the rest of Enfield. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. That is why they are crated the way they are. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The chimney breast in the corner has usually been left in place, so the run gains a return and two scribed ends. These kitchens are nearly always retiled at least twice, and stripping the old tiles takes the bottom course of plaster with it because the original laminate top ran underneath the tiles rather than up to them. Decided before fabrication starts. When the old dividing wall comes out you are left with a nib and a beam - agree whether the worktop dies into the nib or runs past it before templating, it changes the joint position.

Easiest access in the borough. Wide roads built for the industrial estate, verge parking, and most houses have a driveway or a dropped kerb, so the van can back up close to the door. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Siliconed to the worktop, never grouted. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Same batch, same run, same day.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Long runs almost never take a single panel, so the joint positions want agreeing before anything is templated. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

An intruding steel column, a brick pier or a downstand breaks a run that would otherwise have been one clean piece. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. Make the wall good first, or accept the detail. The old tiling must be off and the wall made good and dry before templating, not on fitting day. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Full-height panels need the wall made good first, which is another trade and another timescale. The wall has to be ready.