Worktop templating in Broad Green

Yes. Broad Green is on the patch, and the postcodes we work here are CR0. It is worked on our south London run, along with the rest of Croydon. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. The template plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. Two to three hours, once the units are in. Short runs and multiple small kitchens in one building make this a job to batch, cutting several 2.4m pieces off one slab rather than treating each flat as a separate order.

London Road is a bus corridor with double reds, so the van goes on a side street and the carry is 50 metres or more. Flats above shops are reached by a separate street door and a straight steep stair. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The template records it along with everything else.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop fabrication and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Batching several kitchens together is the one situation where buying a whole slab is cheaper per kitchen rather than more expensive. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first. A licensed shared house has fire-door and escape-route rules that decide how and when stone can be carried through the common parts. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.