Kitchen worktops in Bulls Cross

Yes. Ribbon development strung along Bulls Cross and Bullsmoor Lane - mostly detached and semi-detached houses of varying dates with kitchens at the rear opening onto a large plot. A lot of these are extended once and then re-fitted, so you get a 4m run with a mismatched older section still in place. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause.

ribbon-development semi, green-belt detached and converted lodge. Wider halls make the carry noticeably easier, and that alone can remove a join that a narrower terrace would have forced into the run. Lath-and-plaster and bowed brickwork mean we template for scribes rather than straight cuts, and each piece is offered up and eased in rather than dropped straight down. Units kept, surface changed, one day.

Houses sit directly on a fast through-road with no footway on one side, so unloading needs cones and a spotter. Most have a drive but reversing in against traffic is the risk. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. It sets what the day actually looks like.

Worktop replacement, worktop templating and worktop installation, in that order. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. Where an old extension meets the original kitchen you are joining two different floor levels - decide early whether to level the units or step the worktop, it changes the price.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. The units stay, the surface changes. Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.