Kitchen worktops in Freezywater

Yes. Semis on generous plots near Bullsmoor Lane, most with a utility or a lean-to off the back of the kitchen, so the main run stays short and the messy stuff moves next door. Typical spec is a 3m run plus a separate 1.5m utility top in the same material. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. The waste run is planned, not improvised.

1930s semi, post-war semi and 1980s cul-de-sac house. The back door frequently opens straight into the kitchen, which is the best carry route in the house and the one people forget to mention. The kitchen is normally the original back room with a later side-return or rear extension bolted on, and that helps us: most pieces can go down the side alley and in through the back door in one length, so we can avoid joins that a front-door route would force. Units kept, surface changed, one day.

Straightforward - driveways, dropped kerbs and low front walls. The A10 and Bullsmoor Lane are fast roads with no stopping, so approach from the residential side. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. It sets what the day actually looks like.

Worktop replacement, worktop templating and worktop installation, in that order. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. Utility tops here almost always need a cut-out for a plumbed-in washer and a butler sink at a different height to the main kitchen - confirm the two heights separately at template.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.