Worktop fabrication in Freezywater

Yes. Freezywater is on the patch, and the postcodes we work here are EN3. It is worked on our north London run, along with the rest of Enfield. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

There is usually a shared rear alley, and whether the gate onto it is unlocked decides whether long pieces come in from the back. What does drive the bench work is the knocked-through kitchen-diner: the return worktop and any peninsula are seen end-on from the dining side, so we nest the pieces so the veining carries across the internal corner in the same direction rather than turning through ninety degrees. Settled on the drawing, cut once. Utility tops here almost always need a cut-out for a plumbed-in washer and a butler sink at a different height to the main kitchen - confirm the two heights separately at template.

Straightforward - driveways, dropped kerbs and low front walls. The A10 and Bullsmoor Lane are fast roads with no stopping, so approach from the residential side. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Machined to the real line. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. The approved drawing is the instruction.