Worktop templating in Bunhill

Yes. Bunhill is on the patch, and the postcodes we work here are EC1Y, EC2A. It is worked on our north London run, along with the rest of Islington. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original brickwork is uneven by ten millimetres or more across a bay, so the back edge is scribed to the actual face rather than to a line. Where a column, downstand or steel plate lands in the run, the template plots its actual outline so the stone is cut to fit around it instead of being stopped short and filled. Recorded as it is, not as it was drawn. Managing agents here run tight access rules, so confirm lift dimensions and protection requirements in writing at template stage rather than turning up with a full van.

Congestion Charge zone with red routes on City Road and Old Street, plus a low-traffic scheme covering the residential streets behind. Tower access runs through a booked service lift and an agreed delivery window with the managing agent. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A deep scribe comes out of the nest, so how far the stone has to be relieved changes which part of the slab the piece is cut from. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. That is why the visit takes two or three hours. Units fixed and levelled, all steelwork and brick cleaned, sealed and finished, and any boarded sections completed to final thickness so the template picks up the surface the stone will actually meet. Quartz is the sensible default in a rental: nothing to seal, nothing to maintain, and nothing an incoming tenant needs briefing on. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.